Durabase Designer Conservatory Bases

DURABASE - The Options

DURABASE Base and Wall Systems
Dwarf Wall Conservatory Base System (U.K. patent no. 2 351096) Standing on concrete pads and bolted to the house wall, this system gives a level accurate footing to build your conservatory wall. Manufactured to the exact size required and levelled by screw adjusters under the feet, it eliminates the need for accurate setting out and full scale footings. The outer skin of the wall can be extended by up to 600mm below d.c.m. overcoming difficulties experienced on most sloping sites. The base is completed with an insulated, suspended floor.

	Modular Conservatory Base System A fast, clean solution to the problems of traditional brickwork, eliminating the need for a bricklayer on site. The wall consists of a strong galvanised frame with specially profiled building board made to the exact size and shape of your conservatory, providing a base onto which genuine clay brick tiles are bonded to give a tough lightweight brick wall system. The frames are pre-clad and pre-pointed just leaving the bridging tiles to be inserted over the frame joins. The hollow frames can conceal plumbing, electrical cables and insulation material. This system incorporated with our prefabricated base system is delivered to site ready made, allowing your conservatory to be installed in the minimum of time.
Full height panel/glass to ground Conservatory Base System Standing on concrete pads and bolted to the house wall, this system is a fast, clean and efficient way of providing an accurate and level footing for your full height conservatory. The conservatory sill fits directly to the outer beam of the base and is completed with an insulated floor. The exterior of the base can be finished with a choice of cladding, including uPVC board, wood, pyroc or a brick clad fascia.

DURABASE Pre-fabricated dwarf walls for conservatories

The Durabase Modular wall system offers a revolutionary method of building brick dwarf walls for conservatories. Factory produced walls, indistinguishable from the real thing, eliminate bricklaying and dramactically speeds up construction time whilst maintaining a consistently high standard of appearance.

Plaster finish inside

Brick finish outside

The panels are supplied fully clad but with alternate end brick slips missing. Spare slips are supplied together with adhesive and special pointing mortar so that once the panels are bolted together the missing slips are applied and then pointed to give a continuous finish and invisible joint.

Panel ends are pre-drilled to ensure a perfect alignment and ribbing to ensure the slips line up correctly. The panels are a lightweight, dry and instant wall construction which will greatly reduce construction time and eliminate mess usually associated with bricklaying, i.e water, cement, brick, rubble and dust.

Installation does not require fine weather and the conservatory installation can continue immediately the walls have been installed with no waiting for cement bonds to cure as with conventional construction.

Galvanised steel frames with a cavity for services and insulation